subject
Engineering, 19.10.2019 03:30 genyjoannerubiera

Card flipper: you walk into a room, and see a row of n cards. each one has a number xi written on it, where i ranges from 1 to n. however, initially all the cards are face down. your goal is to find a local minimum: that is, a card i whose number is less than or equal to those of its neighbors, xi-1 > = xi < = xi+1. the first and last cards can also be local minima, and they only have one neighbor to compare to. there can be many local minima, but you are only responsible for finding one of them. obviously you can solve this problem by turning over all n cards, and scanning through them. however, show that you can find such a minimum by turning over only o(log n) cards.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
image
Engineering, 04.07.2019 18:10, lerasteidl
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
You know the right answer?
Card flipper: you walk into a room, and see a row of n cards. each one has a number xi written on i...

Questions in other subjects: