Engineering, 18.10.2019 20:30 coolestkid2401

Two streams flow into a 500 us gallon tank. the first stream is 10.0 wt% ethanol and 90.0 wt% hexane and has a density of rho1 = 0.68 g/cm3 . the second stream is 90.0 wt% ethanol and 10.0 wt% hexane and has a density of rho2 = 0.78 g/cm3 . after the tank is filled, which takes 22 min, the mixture is 60.0 wt% ethanol and 40.0 wt% hexane. a) draw and label the diagram for this system. b) estimate the density of the mixed stream. use this density to calculate the final mass of the mixture in the filled tank. c) calculate the mass (in kg/min) and volumetric (in l/min) flow rates of the two streams, assuming that they fill the tank at a constant rate

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

You know the right answer?

Two streams flow into a 500 us gallon tank. the first stream is 10.0 wt% ethanol and 90.0 wt% hexane...