Engineering, 18.10.2019 17:20 gumbyseth1969p45qjl

Consider that only a single tcp(reno) connection uses one 10mbps link which does not buffer any data. suppose that this link is the only congested link between the sending and receiving hosts. assume that the tcp sender has a huge file to send to the receiver, and the receiver's receive buffer is much larger than the congestion window. we also make the following assumptions: each tcp segment size is 1,500 bytes; the two-way propagation delay of this connection is 100msec; and this tcp connection is always in congestion avoidance phase, that is, ignore slow start.
a) what is the maximum window size(in segments) that this tcp connection can achieve?
b)what is the average window size(in segments) and the average throughput(in bps) of this tcp connection?
c) how long would it take for this tcp connection to reach its maximum window again after recovering from the packet loss?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

You know the right answer?

Consider that only a single tcp(reno) connection uses one 10mbps link which does not buffer any data...