subject
Engineering, 17.10.2019 06:00 anna8352

Aparallel plate capacitor has an air filled gap. it is attached an emf and charged it to charge qo and voltage difference δvco. two different experiments are done. case a: the capacitor is disconnected from the emf first before the gap in between the plates is then filled with teflon. case b: the gap between the capacitor plates is then filled with teflon with the capacitor still connected directly across the terminals of the emf. which statement is true after the teflon is inserted into the gap? a. in case a, δvc is unchanged but q decreases to keep the net e field between the plates unchanged. in case b, q is unchanged but δvc increases due to a larger net e field between the plates. b. in case a, q is unchanged but δvc increases due to a larger net e field between the plates. in case b, δvc is unchanged but q decreases to keep the net e field between the plates unchanged. c. in case a, δvc is unchanged but q increases to keep the net e field between the plates unchanged. in case b, q is unchanged but δvc decreases due to a smaller net e field between the plates. d. in case a, q is unchanged but δvc decreases due to a smaller net e field between the plates. in case b, δvc is unchanged but q increases to keep the net e field between the plates unchanged.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, sarahgrindstaff123
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
image
Engineering, 04.07.2019 18:10, wirchakethan23
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
image
Engineering, 04.07.2019 18:20, miguel454545
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
image
Engineering, 04.07.2019 19:10, alex6toes
What are the major differences between injection molding and extrusion?
Answers: 2
You know the right answer?
Aparallel plate capacitor has an air filled gap. it is attached an emf and charged it to charge qo a...

Questions in other subjects:

Konu
Mathematics, 09.11.2020 16:30