subject
Engineering, 16.10.2019 23:30 alemvp8219

3. an average household in iowa consumes 4700 kwh of electricity annually. consider a pv solar system consisting of monocrystalline silicon modules, each rated at 200 w and have a surface area of 2 m2. assume the pv modules have an overall solar-electric conversion efficiency of 18% and an expected power output of 140 w in this system with the rated solar flux of 1000 w/m2. the system is grid connected and participates in net metering where excess electricity generated is "banked" and provided back to homeowner at no cost. based on this there is no need for storage. a. at what tilt should the pv modules be fixed to utilize greatest amount of the annual solar radiation?

b. based on the average solar resource determined in part (a), what is the minimum number pv modules that are required to generate 100% of the electricity used by the household?

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
image
Engineering, 04.07.2019 18:20, miguel454545
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
image
Engineering, 05.07.2019 04:30, kookycookiefanx
Technician a says that in a worm gear steering system, most excessive steering free play is usually found in the gearbox. technician b says that in a rack-and-pinion steering system, excessive free play can be found in the bushings. who is correct?
Answers: 2
image
Engineering, 06.07.2019 02:30, Nonniel0v3
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
You know the right answer?
3. an average household in iowa consumes 4700 kwh of electricity annually. consider a pv solar syste...

Questions in other subjects: