subject
Engineering, 15.10.2019 19:20 AutumnJoy12

One mole of tungsten (6 1023 atoms) has a mass of 184 grams, and its density is 19.3 grams per cubic centimeter, so the center-to-center distance between atoms is 2.51 10-10 m. you have a long thin bar of tungsten, 2.9 m long, with a square cross section, 0.12 cm on a side. you hang the rod vertically and attach a 265 kg mass to the bottom, and you observe that the bar becomes 1.45 cm longer. from these measurements, it is possible to determine the stiffness of one interatomic bond in tungsten. 1) what is the spring stiffness of the entire wire, considered as a single macroscopic (large scale), very stiff spring? ks = n/m 2) how many side-by-side atomic chains (long springs) are there in this wire? this is the same as the number of atoms on the bottom surface of the tungsten wire. note that the cross-sectional area of one tungsten atom is (2.51 10-10)2 m2. number of side-by-side long chains of atoms = 3) how many interatomic bonds are there in one atomic chain running the length of the wire? number of bonds in total length = 4) what is the stiffness of a single interatomic "sprin

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 03:10, lauriepdx17
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
image
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, dval1146
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
You know the right answer?
One mole of tungsten (6 1023 atoms) has a mass of 184 grams, and its density is 19.3 grams per cubic...

Questions in other subjects:

Konu
Mathematics, 06.03.2021 17:40
Konu
Mathematics, 06.03.2021 17:40
Konu
Mathematics, 06.03.2021 17:40