Engineering, 11.10.2019 05:00 Lamr
There are 20 automatic turning machines in the lathe department. batches of parts are machined in the department, each batch consists of setup and run times. batch size = 100 parts. the standard time to set up a machine for each batch is 5.0 hours. four setup workers perform the setups. they each work 40 hours per week. once a machine is set up, it runs automatically, with no worker attention until the batch is completed. cycle time to machine each part = 9.00 min; thus, it takes 15 hours of run time to produce a batch. assume all machines are perfectly reliable. what is the production output of the lathe department in 40 hours of operation per week?
Answers: 3
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10, settasav9641
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
There are 20 automatic turning machines in the lathe department. batches of parts are machined in th...
Questions in other subjects:
History, 27.06.2019 08:40
History, 27.06.2019 08:40
