Engineering, 10.10.2019 21:30 trvptrav

Personal trainer, inc. owns and operates fitness centers in a dozen midwestern cities. the centers have done well, and the company is planning an international expansion by opening a new "supercenter" in the toronto area. personal trainer’s president, cassia umi, hired an it consultant, susan park, to develop an information system for the new facility. during the project, susan will work closely with gray lewis, who will manage the new operation.

background

susan park has completed a preliminary investigation and performed the fact-finding tasks that were described in chapters 2 and 4. now, she will use the results to develop a logical model of the proposed information system.

tasks

before you perform the following tasks, you should review the information provided in chapters 2 and 4 of the case.

(1) prepare a context diagram for the new system.
(2) prepare a diagram 0 dfd for the new system.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

You know the right answer?

Personal trainer, inc. owns and operates fitness centers in a dozen midwestern cities. the centers h...