Engineering, 10.10.2019 00:00 StupidFatChipmunk

1. what is the linear distance traveled in one revolution of a 9 in diameter wheel?

2. an industrial water shutoff valve is designed to operate with 15 ib of effort force. the valve will encounter 155 ib of resistance force applied to a 0.85 in diameter axle. what is the actual mechanial advantage of the sytem?

3. if the diameter of the wheel is 10.5 inches, what is the efficiency of the wheel and axle system?

4. a block and tackle system with 8 supporting strands is used to lift materials in a manufacturing facility. the motor being used to wind the cable in the pulley system can provide 200 ib of force. what is the ideal mechanical advantage of the pulley system?

5. ideally what is the maximum weight of materials that can be lifted?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, niicoleassssssf

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

You know the right answer?

1. what is the linear distance traveled in one revolution of a 9 in diameter wheel?

2....