Engineering, 09.10.2019 04:10 garrettm162

5. consider a 200 kw fuel cell combined heat and power (chp) plant that is fueled with natural gas that has a lower heating value of 48.3 mj/kg. based on the lower heating value of the fuel, the power plant has a heat rate of 9000 btu/kwhe. the heat rate accounts only the production of electricity from the fuel cell and not the delivery of heat. the capacity factor of the plant is 60%. the fuel cell is a combined heat and power (chp) plant which produces 300,000 btu/h of heat energy at the rated power of 200 kw. what is the lower heating value combined heat and power efficiency of the plant (%)?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, mirmir62

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

continue

You know the right answer?

5. consider a 200 kw fuel cell combined heat and power (chp) plant that is fueled with natural gas t...