Engineering, 07.10.2019 22:20 maddigrace3

Need asap
1. what material is specified?

2. what tolerances are allowed on:

(a) decimal dimensions?

(b) fractional dimensions?

(c) angular dimensions?

3. what heat-treating process is required after rough machining?

4. determine overall basic dimensions a b c.

5. what is the radius of all fillets and rounds?

6. compute dimensions d and e .

7. how many holes are .500?

8. how many external threads are to be cut?

9. what thread series is used for the internal and external threads?

10. what does 3/4 - 16unf - 2a - lh mean?

11. what are the upper- and lower-limits of the .7500 diameter portion?

12. what does 1 1/2 - 16un - 3a - lh mean?

13. what does .312 - 18unc - 1b mean?

14. what is the lower-limit diameter of the unthreaded 1 1/20 diameter portion?

15. determine the length of the 1 1/20 - 16 threaded portion.

16. how many holes are to be threaded 10 - 32unf?

17. how deep are the holes to be threaded?

18. give the angle to the horizontal at which the 10 - 32unf holes are to be drilled.

19. give the diameter of the circle on which the 10 - 32unf tapped holes are located.

20. identify the system of dimensioning used on the drawing of the rocker base.

21. change the decimal and angular tolerances so they apply in one direction (1) only. then, determine the upper- and lower-limit dimensions for a , b , c , d , e , and the 45° angle.

Need asap1. what material is specified? 2. what tolerances are allowed on:

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

You know the right answer?

Need asap
1. what material is specified?

2. what tolerances are allowed on:
...