Engineering, 07.10.2019 22:20 chrismeldajbaptiste

Need asap
1. name the view that shows the width (height) of the coupling.

2. name the view in which the holes are shown as circles.

3. name the kind of line shown at e, f, g, h, i, and j.

4. what circle represents the 4.500 diameter flange?

5. what circle represents the 1. diameter?

6. name the kind of line shown at n.

7. how many holes are to be drilled in the larger flange?

8. indicate the drill size to be used.

9. give the diameter circle on which the equally spaced holes are drilled in the larger flange

10. how many holes are to be drilled in the smaller flange?

11. how deep is the 1.250 diameter hole?

12. give the diameter of the reamed holes.

13. state the angle with the horizontal center line used for locating reamed hole o.

14. what is the overall width (height) of the coupling?

15. what is the diameter of the smaller flange?

16. what is the diameter of the circle a and b?

17. what is the depth of the 1.000" hole?

18. what is the thickness of the larger flange?

19. if 5/16" bolts are used in the 7 drilled holes, what will be the clearance between the hole and the bolt?

20. determine distances c and d.

Need asap1. name the view that shows the width (height) of the coupling.2.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, lowkeyqueenk

Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk

Answers: 1

continue

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

You know the right answer?

Need asap
1. name the view that shows the width (height) of the coupling.

2. name t...