Engineering, 07.10.2019 02:10 glocurlsprinces

Why should a coworker sigh off as a witness for an engineering notebook?

a. to double check the work.
b. many engineers skip this essential step.
c. because fraud is common in engineering
d. this step is needed only for inexperienced engineers.

2. a closed system

a. requires permission to access.
b. is particularly difficult to study.
c. prevents elements from leaving.
d. does not contain natural elements.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, genyjoannerubiera

Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)

Answers: 1

continue

Engineering, 04.07.2019 18:10, demarcuswiseman

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

Engineering, 04.07.2019 19:10, batmanmarie2004

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

continue

You know the right answer?

Why should a coworker sigh off as a witness for an engineering notebook?

a. to double c...