Engineering, 05.10.2019 00:20 machapman6594

3. exhaust gas from a chemical process flows at a rate of 8000 acfm from point a at 250 degrees f and 1 atm pressure. it is flows through a circular duct to a fan where the pressure is boosted by 4 inches of water and then flows to an incinerator. fuel gas is burned at a rate of 75 pounds per hour and the temperature of the exhaust gas is 1200 degrees f. assuming both the process exhaust and incinerator exhaust streams have properties similar to air, calculate the enthalpy that has been added by burning the fuel gas. assume that you can recover heat from the incinerator exhaust by purchasing aheat exchanger to cool the gases to 500 degrees f while recovering the useful heat. assuming that such heat is worth $7/million btu, how much money could you save by recovering the heat ($/day)

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

You know the right answer?

3. exhaust gas from a chemical process flows at a rate of 8000 acfm from point a at 250 degrees f an...