Engineering, 04.10.2019 19:10 lefarrioe8621
(uscs units) a face milling operation is performed on the top surface of a steel block that is 12.0 in long by 2.0 in wide by 2.5 in thick. the milling cutter follows a path that is centered over the width of the block. it has five teeth and a 3.0 in diameter. cutting speed = 250 ft/min, feed = 0.006 in/tooth, and depth of cut = 0.150 in. determine (a) machining time and (b) maximum metal removal rate during the cut. (c) if an additional approach distance of 0.5 in is provided at the beginning of the pass (before cutting begins), and an overtravel distance is provided at the end of the pass equal to the cutter radius plus 0.5 in, what is the duration of the feed motion?
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, tobyhollingsworth178
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
Engineering, 04.07.2019 18:10, krystabrewer3
What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information
Answers: 3
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
(uscs units) a face milling operation is performed on the top surface of a steel block that is 12.0...
Questions in other subjects:
Social Studies, 03.07.2019 12:30
Mathematics, 03.07.2019 12:30
Biology, 03.07.2019 12:30
English, 03.07.2019 12:30
