Engineering, 05.10.2019 13:00 cmaya

Acapillary viscometer is being used to measure the viscosity of a liquid at 20 c. the capillary tube is 0.01 cm in diameter and has a length of 100 cm. when the pressure drop over the length of this capillary tube was 2 atm, the flow rate of the liquid was found to be 1.0 cm^3 h^-1. what is the viscosity of the liquid in cp? the density of the liquid is 1.025 g cm^3.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, viicborella

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

continue

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

You know the right answer?

Acapillary viscometer is being used to measure the viscosity of a liquid at 20 c. the capillary tube...