Engineering, 05.10.2019 13:30 foriegnngal

Africtionless piston-cylinder with stops has an initial volume of 1.2 m^3 and contains 2.4 kg of water with an initial temperature of 100°c. at this state, the piston is partially supported by a set of stops. the mass of the piston is such that a pressure of 300 kpa is required to lift the piston off of the stops. the system is heated until the temperature is 250°c. a. determine the initial pressure of the water b. if the piston lifts off the stops during the process, find the temperature when the piston first begins to rise. if the piston doesn't lift off the stops, determine the final pressure. c. calculate the work for the process. d. calculate the heat transfer for the process. e. show the entire process on p-v and t-v diagrams.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, selenamr

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

continue

Engineering, 04.07.2019 18:20, samantha636

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

Engineering, 04.07.2019 18:20, xcapo1x

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

continue

You know the right answer?

Africtionless piston-cylinder with stops has an initial volume of 1.2 m^3 and contains 2.4 kg of wat...