subject
Engineering, 03.10.2019 03:10 mauri6381

Acentrifugal pump delivers 227 m^3 /hr of water from a source 4 meters below the pump centre line to a pressure tank whose pressure is 2.8 kg/cm2 . friction loss estimates are 2 meters in the suction line and 1 metre in the discharge line. the diameter of the suction pipe is 250 mm and the discharge pipe is 200 mm. find: a) the water horsepower b) the kw rating of the driving motor if the pump efficiency is 70%

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, jadeochoa4466
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, ashleybaber4966
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
You know the right answer?
Acentrifugal pump delivers 227 m^3 /hr of water from a source 4 meters below the pump centre line to...

Questions in other subjects:

Konu
Mathematics, 24.06.2019 07:50
Konu
Mathematics, 24.06.2019 07:50
Konu
Mathematics, 24.06.2019 07:50
Konu
Mathematics, 24.06.2019 07:50