Engineering, 01.10.2019 02:20 batmannn1516

Two pipes with length, thickness and outer diameter of 4-m, 0.4-cm and 10 cm, respectively, are used for transporting superheated vapor in a manufacturing plant. the pipes with thermal conductivity of 55 w/m. k are connected to each other through two 1- cm-thick flanges of outer diameter 19 cm. the superheated vapor flows inside the pipe at an average temperature of 483 k with a heat transfer coefficient of 180 w/m2 .k. air condition surrounding the pipes has a temperature of 283 k and a convection heat transfer coefficient of 25 w/m2 .k. (a) determine the average outer surface temperature of the pipe, disregarding the flanges. (b) considering the flanges as the fins and using this temperature for the base of the flange, determine the fin efficiency and the rate of heat transfer from the flanges. (40 points)

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 04.07.2019 18:20, kodyclancy

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Engineering, 04.07.2019 19:20, mariahmimibrooks

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

continue

You know the right answer?

Two pipes with length, thickness and outer diameter of 4-m, 0.4-cm and 10 cm, respectively, are used...