Engineering, 22.09.2019 01:30 cieswa46054
Abronze bushing, with an inside diameter of 88.9 + q/1000 mm and a nominal outside diameter of 101.6 + q/1000 mm, is pressed into a steel sleeve having an outside diameter of 114.3 + q/1000 mm. for an fn3 class of fit, specify the dimensions of the parts, the limits of interference, and the stresses created in the bushing and the sleeve. use the basic hole system.
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 19:10, juneham
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
Abronze bushing, with an inside diameter of 88.9 + q/1000 mm and a nominal outside diameter of 101.6...
Questions in other subjects:
History, 20.09.2019 16:10
Mathematics, 20.09.2019 16:10
Mathematics, 20.09.2019 16:10
