Engineering, 18.09.2019 23:30 gtrsoccer

The hot water pipe leaving a residential water heater is not insulated. the water flowing inside is maintained at 49 °c and has a convection coefficient of 234 w/m2 k. the inside diameter of the copper (400 w/mk) pipe is 0.745 inches; the wall thickness is 0.065 inches. the temperature and the convection coefficient of the air surrounding the pipe are 15 °c and 16 w/m2 k respectively. determine the heat loss per unit length of uninsulated pipe, and the temperature of the outer surface. determine the heat loss and the outermost surface temperature for the same conditions with the pipe insulated using 3/8"-thick insulation whose thermal conductivity is 0.034 w/mk. do the surface temperatures of the copper pipe change with the addition of insulation?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, aliopqwas

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

You know the right answer?

The hot water pipe leaving a residential water heater is not insulated. the water flowing inside is...