Engineering, 17.09.2019 22:20 Jennifer16253

1.7 [15] < §1.6> compilers can have a profound impact on the performance of an application. assume that for a program, compiler a results in a dynamic instruction count of 1.0e9 and has an execution time of 1.1 s, while compiler b results in a dynamic instruction count of 1.2e9 and an execution time of 1.5 s.(a) find the average cpi for each program given that the processor has a clock cycletime of 1 ns.(b) assume the compiled programs run on two different processors. if the executiontimes on the two processors are the same, how much faster is the clock of theprocessor running compiler a’s code versus the clock of the processor runningcompiler b’s code?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 19:20, zoebtharpe

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

continue

Engineering, 04.07.2019 19:20, rosemary909

In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.

Answers: 3

continue

You know the right answer?

1.7 [15] < §1.6> compilers can have a profound impact on the performance of an application. a...