Engineering, 14.09.2019 04:20 TatlTael7321

Aski lift has a one-way length of 1 km and a vertical rise of 200 m. the chairs are spaced 20 m apart, and each chair can seat three people. the lift is operating at a steady speed of 10 km/h. neglecting friction and air drag, and assuming that the average mass of each loaded chair is 250 kg, determine the power required to operate this ski lift. also, estimate the power required to accelerate this ski lift in 7 s to its operating speed when it is first turned on. the power required to operate the ski lift is kw. the power required to accelerate this ski life in 7 s to its operating speed is kw.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:20, DroctorWellsfan

Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above

Answers: 1

continue

Engineering, 04.07.2019 19:10, lexie223

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

continue

Engineering, 06.07.2019 02:30, emiller6462

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

continue

You know the right answer?

Aski lift has a one-way length of 1 km and a vertical rise of 200 m. the chairs are spaced 20 m apar...