Engineering, 14.09.2019 03:10 cc72501
Athree-point bend test is performed on a block of silicon carbide that is 10 cm long, 1.5 cm wide, and 0.6 cm thick and is resting on two supports 7.5 cm apart. the sample breaks when a deflection of 0.09 mm is recorded. the flexural modulus for silicon carbide is 480 gpa. assume that no plastic deformation occurs. calculate (a) the force that caused the fracture; and (b) the flexural strength.
Answers: 3
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
Engineering, 04.07.2019 19:10, jimena15
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
Athree-point bend test is performed on a block of silicon carbide that is 10 cm long, 1.5 cm wide, a...
Mathematics, 08.06.2020 18:57
Mathematics, 08.06.2020 18:57
Health, 08.06.2020 18:57
Health, 08.06.2020 18:57