subject
Engineering, 14.09.2019 02:20 zairamori14

As a body is projected to a high altitude above the earths surface, the variation of the acceleration of gravity with respect to altitude y must be taken into account. neglecting air resistance, this acceleration is determined from the formula a=− g 0 [ r 2 /(r+y ) 2 ] , where g 0 = 9.81 m/ s 2 is the constant gravitational acceleration at sea level, r = 6356 km is the radius of the earth, and the positive direction is measured upward. with what velocity does the particle strike the earth if it is released from rest at an altitude y0 = 800 km?

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
image
Engineering, 04.07.2019 19:20, amandaaarmentaa
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
image
Engineering, 06.07.2019 04:10, j015
Apinion having 30 involute teeth of 6,5 module rotates at 220 r/min and transmits 2 kw to a gear wheel having 70 teeth; the addendum on both wheels is 4 of the circular pitch and the angle of obliquity is 200. determine; 3.1 the lengths of the path of approach and the arc of approach 3.2 the normal force between the teeth at an instant when there is only one pair of teeth in contact
Answers: 2
You know the right answer?
As a body is projected to a high altitude above the earths surface, the variation of the acceleratio...

Questions in other subjects:

Konu
Biology, 03.09.2020 07:01
Konu
Mathematics, 03.09.2020 07:01
Konu
Computers and Technology, 03.09.2020 07:01