subject
Engineering, 13.09.2019 23:30 cheesedoodle

An engineer machines annealed copper in an orthogonal machining experiment. given: cutting speed: 4m/min(13.1 ft/min) depth of cut: 1.17 mm (0.046 in) machine efficiency; 98% width of cut 6 mm (0.236 in) tool material: aluminum oxide coated carbide tool geometry: 2degree relief angle. -5degree rake angle, 5degree clearance angle. 1.75mm (0.069 in) nose radius cutting fluid: synthetic oil (coefficient of friction -0.1) use us standard units for all your work. calculate the shear angle when machining with synthetic oil. calculate the required horse power for the machine engine (motor).

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, BardiFan
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, mm016281
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
image
Engineering, 04.07.2019 18:10, selenamr
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
You know the right answer?
An engineer machines annealed copper in an orthogonal machining experiment. given: cutting speed:...

Questions in other subjects: