Engineering, 13.09.2019 23:30 SillyEve

Phase difference is: select one: 1. the angle difference of a point on waveform from the origin 2. the angle between points of three time wave forms 3. the offset between the crests of two time waveforms 4. the offset between the troughs of the two time waveforms 5. the offset between similar points of the two time waveforms

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

You know the right answer?

Phase difference is: select one: 1. the angle difference of a point on waveform from the origin 2....