Engineering, 13.09.2019 16:10 jewelia2801

Replace the loading acting on the beam by a single
resulantforce. specify where the force acts, measured from b.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

Engineering, 06.07.2019 02:30, heavenwagner

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

continue

Engineering, 06.07.2019 03:20, mardell2587

Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing

Answers: 3

continue

You know the right answer?

Replace the loading acting on the beam by a single
resulantforce. specify where the force acts...