Engineering, 11.09.2019 02:20 Asterisk

Electrically heated draw batch furnaces are commonly used in the heat treatment industry. consider a draw batch furnace front made of a 20-mm thick steel plate with a thermal conductivity of 37 w/m·k. the furnace is situated in a room with surrounding air temperature of 20°c and an average convection heat transfer coefficient of 10 w/m2·k. if the inside surface of the furnace front is subjected to uniform heat flux of 5 kw/m2 and the outer surface has an emissivity of 0.30, determine the inside surface temperature of the furnace front in k. (round your answer up to 2 decimal places.) the stefan–boltzmann constant is 5.67 × 10-8 w/m2 . k4

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:20, RiverH246

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

You know the right answer?

Electrically heated draw batch furnaces are commonly used in the heat treatment industry. consider a...