Engineering, 10.09.2019 21:20 dontcareanyonemo

Cablesplice, inc.’s manufacturing process consists of five steps: making conductors, adding insulation, adding sheathing, irradiation, and printing and coil cutting. units are measured in meters. in 970,000 meters of cable, 700 defects were found in the conductors, and 75,000 defects were found in the insulation. in 440,000 meters of cable, 8,930 defects were found in the sheathing, and no defects were found in the remaining two steps. (a) find dpu and the dpmo, and (b) the sigma level for each process step. evans, james r.. an introduction to six sigma and process improvement (p. 61). south-western college pub. kindle edition.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Engineering, 04.07.2019 18:20, 1230bering

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Engineering, 04.07.2019 18:20, 21megoplin

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

continue

You know the right answer?

Cablesplice, inc.’s manufacturing process consists of five steps: making conductors, adding insulat...