Engineering, 04.09.2019 22:30 KaseyT

Along, circular aluminum rod is attached at one end to a heated wall and transfers heat by convection to a cold fluid.
(a) if the diameter of the rod is tripled, by how much would the rate of heat removal change?
(b) if a copper rod of the same diameter is used in place of the aluminum, by how much would the rate of heat removal change?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, mjcbs21

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

continue

Engineering, 04.07.2019 19:10, santosbeti90

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

continue

You know the right answer?

Along, circular aluminum rod is attached at one end to a heated wall and transfers heat by convectio...