Engineering, 03.09.2019 18:30 uberagentkenny
Technician a says during the manufacturing of a wheel cylinder, the cylinder bore or inside diameter is created by drawing a properly sized ball bearing through the bore, which gives the surface a hard, smooth finish. technician b states that most manufactures recommend replacing rather than honing the wheel cylinder if it has pits or corrosion. who is correct?
Answers: 3
Engineering, 03.07.2019 14:10, cowgyrlup124
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Technician a says during the manufacturing of a wheel cylinder, the cylinder bore or inside diameter...
English, 08.10.2019 17:40
Mathematics, 08.10.2019 17:40
Mathematics, 08.10.2019 17:40
History, 08.10.2019 17:40
Mathematics, 08.10.2019 17:40
Arts, 08.10.2019 17:40