Engineering, 23.08.2019 16:10 1kafran1

Asteam power plant operates on a simple nonideal rankine cycle between the pressure limits of the 10 mpa and 10 kpa in the boiler and condenser, respectively. due to the metallurgic limits in the fabrication of the turbine blades, the maximum temperature in the cycle is not to exceed 500oc. the isentropic efficiency is 85% for both the turbine and the pump. a)show the cycle on a t-s diagram with respect to saturation lines. b)solve for the rate of work done by the compressor on the steam flow. c)determine the rate of heat input and output in the boiler and condenser, respectively, when the power plant operates at its maximum capacity. d) determine the thermal efficiency of the cycle. e) what is the required mass flow rate of the steam through the cycle to generate 210 mw in the power plant?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, salazjlove

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

continue

Engineering, 04.07.2019 18:20, safiyabrowne7594

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

You know the right answer?

Asteam power plant operates on a simple nonideal rankine cycle between the pressure limits of the 10...