Engineering, 23.08.2019 00:10 kikipie8504

A25 mm diameter solid round bar has a groove 2.5 mm deep with a 2.5 mm radius machined into it. the bar is made of aisi 1030 cd steel and is subject to purely reversing bending of 220 n. m. for the s-n curve of this material, let the fatigue strength fraction be equal to 0.9. (a) estimate the number of cycles to failure (b) what is the factor of safety guarding against static failure? (c) if the bar is also placed in an environment with a temperature of 350 oc, estimate the number of cycles to failure

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:20, aly95

An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid

Answers: 3

continue

You know the right answer?

A25 mm diameter solid round bar has a groove 2.5 mm deep with a 2.5 mm radius machined into it. the...