Engineering, 22.08.2019 16:10 Priskittles

The tank is filled with water (p = 997 kg/m), the tank height is 4 m and its surface area is 2 m². the opening at the bottom has a diameter of 1.5x102 m and a surface area of 1.77x10+ m². if the velocity of water escaping at the opening is represented by v = 2.g. h, where g is the gravity acceleration (9.81 m²/s) and h is the height of water inside the tank (m). a. what will be the height of water in the tank after 60 min.? b. how much time it is required to fully empty the tank? c. if a feed stream is introduced into the tank at rate of 7.84x10% (m/s), what will be the final height of water inside the tank?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

You know the right answer?

The tank is filled with water (p = 997 kg/m), the tank height is 4 m and its surface area is 2 m². t...