Engineering, 21.08.2019 05:30 jakemendes1

Apot holding 0.75 liter of water at 20°c is placed on a burner (state 1). the burner electric power is turned to 800 w. because the pot is open to the atmosphere, the pressure remains constant during the entire process and equal to 100 kpa. the water eventually reaches a saturated liquid condition (state 2) at which it begins to boil. the boiling process continues just until all the saturated liquid evaporates (state 3) . a. draw the process on a t-v diagram. b. draw the process on a p-v diagram. c. determine the time between state 1 and state 2. d. determine the time between state 2 and state 3

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tobyhollingsworth178

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

continue

Engineering, 06.07.2019 02:30, heavenwagner

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

continue

Engineering, 06.07.2019 03:30, Scotdouglas346

Acubic shaped box has a side length of 1.0 ft and a mass of 10 lbm is sliding on a frictionless horizontal surface towards a 30 upward incline. the horizontal velocity of the box is 20 ft/s. determine how far up the incline the box will travel (report center of mass distance along the inclined surface, not vertical distance)

Answers: 1

continue

Engineering, 06.07.2019 04:10, blaqsafire9291

Aspherical thermocouple measurement errors a spherical thermocouple made of constantin transfer coefficient between the gas and the thermocouple is h used to measure the temperature of a gas. the heat 400 w/m2 k. calculate the maximum diameter d of the thermocouple if the thermocouple's measurement error should be w 23 within 5% of the initial temperature difference in 5 seconds. for constantin, k 8920 kg/m3, and c 410 j/kg. k.

Answers: 3

continue

You know the right answer?

Apot holding 0.75 liter of water at 20°c is placed on a burner (state 1). the burner electric power...