Engineering, 21.08.2019 01:30 terencehouse

A60 w bulb has a cylindrical tungsten filament 4.3 cm in length with an emissivity of 0.47. assuming that conduction and convection losses and re-radiation from the surroundings are all negligible, find the diameter of the filament if it's operating temperature is 1750 °c. assume this temperature to be uniform at all points in the filament at any given time. use 5.67 x 10 w m² k4 for the stefan-boltzmann constant. a) 2.4 mm b) 0.995 mm c) 23.1 mm d) 1.778 mm e) 0.467 mm

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

Engineering, 04.07.2019 18:20, jessie8022

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

continue

You know the right answer?

A60 w bulb has a cylindrical tungsten filament 4.3 cm in length with an emissivity of 0.47. assuming...