Engineering, 21.08.2019 01:30 HammondE

Asquare thread power screw is designed to provide 150n of lifting force at a rate of 15mm/s. the power screw is driven directly by a motor. the screw has a nominal diameter of 12mm and a pitch of 3mm. the screw-nut combination has a coefficient of friction of 0.06 and there is a 30mm diameter collar with a coefficient of friction of 0.08. a. determine the total torque required to lift the load as described b. determine the required power of the motor c. determine the factor of safety for torsion failure at the root diameter

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 18:20, RiverH246

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

You know the right answer?

Asquare thread power screw is designed to provide 150n of lifting force at a rate of 15mm/s. the pow...