Engineering, 20.08.2019 18:30 sierram298

Consider a (9,6) swcnt that is 1000 nm long and answer the following questions. a. what is the diameter of this swcnt? [the nearest distance in the graphene sheet, b=0.142] b. what is its chiral angle? c. is this tube metallic or semiconducting? d. assuming the elastic modulus of 1500 gpa, how much the nanotube will extend if a force of 1nn or 10-9n is applied along the axis of this tube? [elastic modulus= stress/strain, stress= force/cross-section area, strain= change in length/original length] e. estimate the number of defects in a (9,6) carbon nanotube that extends from earth to international space station (iss) that is approximately 200 miles above earth. the energy needed to create a point defect is 1 ev and assume the temperature to be 300 k

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, michellerosas

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

You know the right answer?

Consider a (9,6) swcnt that is 1000 nm long and answer the following questions. a. what is the diame...