subject
Engineering, 20.08.2019 17:20 abbeygrace13

Asteam power plant operates on the rankine cycle with steam en rankine cycle with steam entering the high pressure turbine at 80 bar, 560°c with a mass flow rate of 2x10 kg/hr. the flow rate of 2x100kg/hr. the steam exits the high pressure turbine at 5 bar, 180°c where the steam is then sent back where the steam is then sent back to the boiler and reheated to 480°c before expanding through the low pressure turbine to cooling water enters the condenser from a lake at 20°c and exits at 32°c. assume the low pressure turbine has an isentropic efficiency of 92% and that the pumps opera isentropically. draw a t-s diagram of this cycle and determine the following: high pressure turbine isentropic efficiency net power output, mw low pressure turbine exit quality cycle thermal efficiency the mass flow rate of the cooling water from the lake

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, brooklyn674
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
You know the right answer?
Asteam power plant operates on the rankine cycle with steam en rankine cycle with steam entering the...

Questions in other subjects:

Konu
Mathematics, 04.03.2021 01:00