Engineering, 17.08.2019 19:10 chloeconlon2014

The roof of a refrigerated truck compartment is of composite construction, consisting of a layer of foamed urethane insulation (t2 50 mm, ki 0.026 w/m k) sandwiched between aluminum alloy panels (t1 5 mm, kp 180 w/m k). the length and width of the roof are l 10 m and w 3.5 m, respectively, and the temperature of the inner surface is ts, i 10c. consider conditions for which the truck is moving at a speed of v 105 km/h, the air temperature is t 32c, and the solar irradiation is gs 750 w/m2 . turbulent flow may be assumed over the entire length of the roof. (a) for equivalent values of the solar absorptivity and the emissivity of the outer surface (s 0.5), estimate the average temperature ts, o of the outer surface. what is the corresponding heat load imposed on the refrigeration system

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, dval1146

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

You know the right answer?

The roof of a refrigerated truck compartment is of composite construction, consisting of a layer of...