Engineering, 12.08.2019 19:10 fatty18

Required information an airplane has a mass of 48,000 kg, a wing area of 300 m2, a maximum lift coefficient of 3.2, and a cruising drag coefficient of 0.03 at an altitude of 12,000 m. take the density of standard air as ρ1 = 1.225 kg/m3 at sea level and ρ2 = 0.312 kg/m3 at 12,000 m altitude. determine the safe takeoff speed at sea level, assuming it is 20 percent over the stall speed. the safe takeoff speed at sea level is km/h.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 19:20, ameliaxbowen7

List 3 options on how to reduce knocking problens during engine process,

Answers: 2

continue

Engineering, 06.07.2019 04:10, makenziemartinez

Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump

Answers: 2

continue

You know the right answer?

Required information an airplane has a mass of 48,000 kg, a wing area of 300 m2, a maximum lift coef...