Engineering, 07.08.2019 17:10 vava1804

Air is compressed from 100 kpa and 15? to a pressure of 1000 kpa while being cooled at a rate of 20 kj/kg by circulating water through the compressor casing. the volume flow rate of the air at the inlet conditions is 140 m/min, and the power input to the compressor is 520 kw determine the mass flow rate of the air and the temperature at the compressor exit. also reconsider the problem using it software, investigate the effect of the rate of cooling of the compressor on the exit temperature of air. let the cooling rate vary from 0 to 200 kj/kg. plot the air temperature against the rate of cooling, and discuss the results.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, yasminothman02

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

You know the right answer?

Air is compressed from 100 kpa and 15? to a pressure of 1000 kpa while being cooled at a rate of 20...