Engineering, 26.07.2019 19:20 jfox8741
The nusselt number is a measure of the a relative magnitude of the diffusivity of momentum and the diffusivity of heat. b. ratio of inertial to viscous forces c enhancement of heat transfer through a fluid laver as a result of convection relative to conduction across the same fluid layer. d. ratio of heat conducted through a body relative to heat stored by a body
Answers: 3
Engineering, 04.07.2019 19:10, netflixacc0107
What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?
Answers: 2
Engineering, 04.07.2019 19:10, juneham
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
Engineering, 06.07.2019 04:10, neariah24
An array of m-50 thermoelectric modules is installed on the exhaust of a sports car. each module has an effective seebeck coefficient of sp of 0.143 5vk and an internal electrical resistance of r.-4 ? in addition, : (15 points each module is of width w 60mm and contains n=100 pairs of semiconducting pellets. each pellet hasan overall length of 2l-5mm and a cross-sectional area as 1.2 x 10'm and is characterized by a thermal conductivity of kpl2w rnk. the hot side of each module is exposed to exhaust gases at·p650c with hia4ow rrk while the osite side of each module is cooled by pressurized water at surface) and 156 °c (at the cool surface). 11s c with h: -500w/m'k. the modules are wired n series and the load resistance is r d=400ohm .the module surface temperatures, t, and ts are 183 "c (at the hot surface and 156c (at the cool surface) a)-draw a schematic of this scenario and label all parts. a. b. if the induced current, i, is 0.15 amps, what is the total power (pa) for one module? c. what is the total power harvest from the exhaust with all 50 modules?
Answers: 2
Engineering, 06.07.2019 05:10, cedricevans41p4j3kx
It has been stated that the quality of the sheared edges can influence the formability of sheet metals. explain why
Answers: 3
The nusselt number is a measure of the a relative magnitude of the diffusivity of momentum and the d...
Geography, 10.04.2021 07:00
Geography, 10.04.2021 07:00
English, 10.04.2021 07:00
Mathematics, 10.04.2021 07:00
Mathematics, 10.04.2021 07:00
Arts, 10.04.2021 07:00