Engineering, 26.07.2019 19:10 QuarkyFermion

Amulti-plate clutch connects two in-line shafts, through 4 plates on the driving and 3 plates driven shaft. the plates have inner and outer diameters 120 and 180mm respectively, with coefficient of friction between the plates of 0.28. the clutch transmits 9 kw at 750 rev/min determine: a)- the axial force between the plates b)- the pressures at the inner and at the outer radi c)- the included angle of a cone clutch that would transmit the same power with the same axial force

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:20, dlr1628

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

continue

Engineering, 04.07.2019 18:20, annette211pdd8v9

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

continue

Engineering, 04.07.2019 19:10, jimena15

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

continue

You know the right answer?

Amulti-plate clutch connects two in-line shafts, through 4 plates on the driving and 3 plates driven...