Engineering, 26.07.2019 19:10 MayFlowers
Why might peck drilling be used instead of standard drilling with a 0.25" diameter hole which is 3 inches deep on a aluminum part? a. to save time b. to reduce temperature and tool wear of the bit c. to keep the flutes fully engaged at all times and increase chip length
Answers: 2
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 19:10, Mimidj9279
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
Why might peck drilling be used instead of standard drilling with a 0.25" diameter hole which is 3 i...
Social Studies, 23.08.2019 17:50
Biology, 23.08.2019 17:50
History, 23.08.2019 17:50
History, 23.08.2019 17:50
Social Studies, 23.08.2019 17:50
Health, 23.08.2019 17:50
English, 23.08.2019 17:50