Engineering, 26.07.2019 18:20 tonehasarathi
Ashaft is loaded in 2kn tension and 100nm torsion. the shaft is made of steel with a 15mm diameter. a. draw the free body diagram for the loading as described. b. determine the normal stress from tension determine the maximum shear stress from torsion d. draw the 2d stress element for the combined load e. determine the maximum normal stress and principal stresses
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 19:10, LadyHolmes67
Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false
Answers: 3
You know the right answer?
Ashaft is loaded in 2kn tension and 100nm torsion. the shaft is made of steel with a 15mm diameter....
Questions in other subjects:
Biology, 26.11.2019 05:31
