Engineering, 26.07.2019 18:10 penelopegrace04

A78-percent-efficient steam boiler is used to generate saturated water vapor at 350°f. water enters the boiler at the steam pressure as a saturated liquid. municipal solid waste (msw) is burned at a rate of 60 lbm/min in the boiler and the heating value of msw is 9000 btu/lbm. the generated steam is run through an ideal turbine-generator unit to generate electricity. the pressure at turbine outlet is 10 psia. determine the rate of steam generation and the power output from the generator.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 19:10, nbunny7208

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

continue

Engineering, 06.07.2019 02:30, Nonniel0v3

An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?

Answers: 3

continue

You know the right answer?

A78-percent-efficient steam boiler is used to generate saturated water vapor at 350°f. water enters...