Engineering, 26.07.2019 17:20 brooke012002

The reason that ay annealing process carl softern a cold-worked fe-c alloy is: a) the annealing pröcess decreases the carbon content in the alloy b) the annealing process increases the dislocation density of the alloy c)the annealing process decreases the dislocation density of the alloy d) the annealing process generates the barriers in the micróstructure of the alloy to prevent dislocation motion.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

You know the right answer?

The reason that ay annealing process carl softern a cold-worked fe-c alloy is: a) the annealing prö...