Put the four main steps of the injection molding process in correct order. (place the correct step number after the text line) a)- injection of plastic with hydraulic ram b)-final part inspection for dimensional accuracy c)- pre-heat and mixing of plastic pellets with screw d)- removal of part for cooling e)- clamping (closing) of mold -

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

What is creep? what is stress relaxation?